Installing – Flat Mount

HOW TO MOUNT A WAKE N GRILL TO YOUR BOAT

Using a Flat Mount

STEP 1

Prepare tools needed.
Kit includes drill card and drill bit.
Tools required: Drill, hammer, starter punch, allen wrenches, tape, and tape measure.
You'll also need the Flat Mount kit to install after initial prep.

STEP 2

Line up drill card.
Situate top of drill card along the top edge of the swim platform bracket. Line up the center of the card approximately 4 inches from stern of boat, ensuring the card is within entire swim platform bracket. Tape sides of drill card to hold in place.

STEP 3

Begin drill holes using starter punch.
Start all four holes that will be drilled through swim platform using starter punch and a hammer.

STEP 4

Drill four holes.
Using started punches, drill completely through swim platform bracket for every hole.

STEP 5

Inspection.
Ensure four holes are completed and free of any debris.

STEP 6

Flat Mount installation.
Attach Flat Mount to swim platform bracket using four bolts provided, ensuring you tighten the provided nuts on the opposite side.

STEP 7

Attaching the lower swim platform arm.
Attach the lower swim platform arm using the provided large bolt. Tighten down using allen wrench.

STEP 8

Attaching the telescoping curved arm.
Pull the plunger out on the lower swim platform arm and rotate 90 degrees to open. Insert the telescoping curved arm, and rotate the plunger back to its home position until the plunger inserts into a hole in the curved arm.

STEP 9

Attach grill platform.
Pull out the plunger from the top of the curved arm and rotate 90 degrees to open. Insert the grill platform, and rotate the plunger back to its home position until the plunger inserts into the notch in the grill platform.